🔌 Router Guides

Engenius SD-WAN Router

3min

This guide is intended to help Engenius SD-WAN Router (ESG) users integrate a security and content filter solution with Flashstart.

1. When you have your router managed through Engenius Cloud, you will be ready for its configuration.

2. Go to the configuration section/Gateway/Interfaces

Document image


3. Enable the Engenius DDNS and assign a name ex: "Flashstart."

Document image


4. Check that the changes have been applied correctly from the general panel of the Gateway

Document image


5. Go to your Flashstart panel and make the following configurations:

Document image

Document image

Document image


Use the same domain that you have previously setup in your Engenius Gateway.

Document image

Document image


In case we are unable to resolve your public IP address, wait a few minutes for the DNS to propagate correctly.

1) Go back to our Gateway and assign the DNS of Flahstart:

185.236.104.104

185.236.105.105

Document image


2) Apply the changes.

Back to the Flashstart panel and we now should have our Engenius SD-WAN router synchronized.

Document image


Other ways to ask: » How to configure on a Engenius SD-WAN router. » Using the Engenius SD-WAN router. Here's how.

Updated 15 Apr 2025
Doc contributor
Doc contributor
Did this page help you?
PREVIOUS
Bright Box configuration
NEXT
Ruijie Router
Docs powered by Archbee