Bind configuration

if you are using bind as your dns server and want to forward all incoming requests to our dns server you can use the malware protection and content filtering features , please follow the steps below for more information on how bind works you can visit the , please follow the steps below for more information on how bind works you can visit the important note before proceeding with this guide, you must register y our public ip address only registered ip addresses can use the malware protection and content filtering features on their network you can do this by going and then accessing the networks section move to the folder that contains the bind configuration files by default, the folder should be /etc/bind the file we need to change is the " named conf options " file, so open it in a text editor with sudo privileges once opened, the file should look something like this > options { "/var/cache/bind" directory; dnssec validation auto; auth nxdomain no; # conform to rfc1035 listen on v6 { any; }; }; within the options {} block we need to create another block called forwarders that will contain the ip addresses of the dns servers to which we want to forward requests in this case the ip addresses to be entered are as follows \> options { directory "/var/cache/bind"; forwarders { 185 236 104 104; 185 236 105 105; }; now we need to set the forward directive to " only ," since our server should automatically forward all requests and not attempt to resolve them on its own the configuration file should look like this when finished > options { directory "/var/cache/bind"; forwarders { 185 236 104 104; 185 236 105 105; }; forward only; save and close the file once you are done to check if you have done everything correctly, we can use the tools provided by bind to check the syntax of the configuration files to do this, simply type the following command \> sudo named checkconf if there are no syntax errors in the configuration, the shell prompt will terminate immediately without displaying any output finally, you need to restart the bind daemon to implement the changes you can do this with the following command (the command below uses bind 9 replace it with the version you are currently using) \> sudo service bind9 restart we're done, and you should now have your bind server properly configured to start filtering content and protecting your network from malware other ways to ask how to configure bind for internet dns filtering configuring bind for internet dns filtering how to