TP-Link configuration

to activate the cloud filter if you have not yet registered for the service you can do so by clicking on the following link if you have not yet registered for the service you can do so by clicking on the following link connect to the control panel by entering the ip address of the tp link in the address bar of any browser then log in by entering your credentials open the \[ network ] menu then go to \[ wan ] finally, click on \[ advanced ] enter the following dns in the primary dns and secondary dns fields , respectively 185 236 104 104 185 236 105 105 at this point it is necessary to activate and configure the dynamic dns service then proceed as follows service provider choose dyndns as your service please note it is not necessary to register for the dyndns service, it will still work since the filter redirects the request to itself username enter your cloud filter registration username password enter your password, which arrived via email to the address specified during registration domain enter a domain name at will for example, domain enable dns check the enable ddns entry click the \[ login ] button to force synchronization and then on \[ save ] to apply the changes please note do not worry if an error message like this appears ddns not launching!!! at this point you can configure the dhcp server to automatically assign network parameters, including our dns , to the various devices to do this click on the \[ dhcp ] menu and then on \[ dhcp settings ] enable the service and configure it as follows start ip address enter the first ip in the range end ip address enter the last ip in the range address lease time choose the length of time the addresses assigned by dhcp are valid (in seconds) default gateway enter the default gateway address of the network default domain enter the domain name of your network, if any primary dns enter as the primary dns this address 185 236 104 104 secondary dns type in as the secondary dns this address 185 236 105 105 important note alternatively, you can set the ip address of the tp link as the only dns this way the clients will use the dns set on the router, which is ours finally, click \[ save ] to apply the changes other ways to ask how to configure tp link router tp link router configuration how to